Netgear XCM8806 Chassis Hardware Installation Guide - Page 964

NETGEAR 8800 Chassis Switch CLI Manual enable rip enable rip aggregation enable rip aggregation Description Enables the RIP aggregation of subnet information on a RIP version 2 (RIPv2) interface. Syntax Description This command has no arguments or variables. Default Disabled. Usage Guidelines The enable (disable) rip aggregation command enables (disables) the RIP aggregation of subnet information on an interface configured to send RIPv1 or RIPv2-compatible traffic. The switch summarizes subnet routes to the nearest class network route. The following rules apply when using RIP aggregation: • Subnet routes are aggregated to the nearest class network route when crossing a class boundary. • Within a class boundary, no routes are aggregated. • If aggregation is enabled, the behavior is the same as in RIPv1. • If aggregation is disabled, subnet routes are never aggregated, even when crossing a class boundary. Example The following command enables RIP aggregation on the interface: enable rip aggregation enable rip export enable rip export [bgp | direct | e-bgp | i-bgp | ospf | ospf-extern1 | ospf-extern2 | ospf-inter | ospf-intra | static ] [cost {tag } | policy ] Description Enables RIP to redistribute routes from other routing functions. Syntax Description bgp Specifies BGP routes. 964 | Chapter 21. RIP Commands