Netgear XCM8806 Chassis Hardware Installation Guide - Page 1122
create bgp neighbor remote-AS-number, outer, RFC 5396
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1122 highlights
NETGEAR 8800 Chassis Switch CLI Manual To add an existing neighbor to a peer group, use the following command: configure bgp neighbor [all | ] peer-group [ | none] {acquire-all} If you do not specify acquire-all, only the mandatory parameters are inherited from the peer group. If you specify acquire-all, all of the parameters of the peer group are inherited. This command disables the neighbor before adding it to the peer group. Example The following command creates a new neighbor and makes it part of the peer group outer: create bgp neighbor 192.1.1.22 peer-group outer create bgp neighbor remote-AS-number create bgp neighbor remote-AS-number {multi-hop} Description Creates a new BGP peer. Syntax Description remoteaddr number multi-hop Specifies an IP address of the BGP neighbor. Specifies a remote AS number. The range is 1 to 4294967295. Specifies to allow connections to EBGP peers that are not directly connected. Default N/A. Usage Guidelines The AS number is a 4-byte AS number in either the ASPLAIN or the ASDOT format as described in RFC 5396, Textual Representation of Autonomous System (AS) Numbers. If the AS number is the same as the AS number provided in the configure bgp as command, then the peer is consider an IBGP peer, otherwise the neighbor is an EBGP peer. The BGP session to a newly created peer is not started until the enable bgp neighbor command is issued. Examples The following command specifies a BGP peer AS number using the ASPLAIN 4-byte AS number format: create bgp neighbor 14.0.0.1 remote-AS-number 4000000000 1122 | Chapter 25. BGP Commands