Netgear XCM8806 Chassis Hardware Installation Guide - Page 449

NETGEAR 8800 Chassis Switch CLI Manual When an IPv6 address is configured for the VLAN, the system may display one of the following two address types in parentheses after the IPv6 address: • Tentative • Duplicate Note: See the NETGEAR 8800 User Manual for information on IPv6 address types. You can display additional useful information on VLANs configured with IPv6 addresses by issuing the show ipconfig ipv6 vlan . The following is sample output from this command: # show ipconfig ipv6 my_ipv6_100 Router Interface on my_ipv6_100 is enabled and up. MTU: 1500  Locally registered unicast addresses:  2001:db8::8:802:200c:417a/64  fe80::230:48ff:fe41:ed97%my_ipv6_100/64  Flags:  IPv6 Forwarding: YES Accept recvd RA: NO Send redirects: NO Accept redirects: NO When a displayed VLAN is part of a PVLAN, the display includes the PVLAN name and type (which is network, non-isolated subscriber, or isolated subscriber). When the displayed VLAN is configured for VLAN translation, the display provides translation VLAN information. If the displayed VLAN is a translation VLAN, a list of translation VLAN members appears. If the displayed VLAN is a member VLAN, the display indicates the translation VLAN to which the member VLAN belongs. Example The following is an example of the show vlan command on the NETGEAR 8806 switch: XCM8806.4 # show vlan Name VID Protocol Addr Flags Proto Ports Virtual Active router /Total alan1 4094 192.18.1.1 /24 -f-----mop ANY 0 /1 VR-Default alan2 4093 192.18.2.1 /24 -f-----mop ANY 0 /1 VR-Default alan3 4092 192.18.3.1 /24 -f-----mop ANY 0 /1 VR-Default alan4 4091 192.18.4.1 /24 -f-----mop ANY 0 /1 VR-Default CISCO-OSPF 4090 111.1.1.2 /24 -f------o ANY 0 /1 VR-Default Default 1 T ANY 3 /90 VR-Default Mgmt 4095 172.26.2.145 /24 ANY 1 /1 VR-Mgmt VLANRIP 4088 123.1.1.1 /24 -f--------r ANY 0 /1 VR-Default Chapter 9. VLAN Commands | 449