Netgear XCM8806 Chassis Hardware Installation Guide - Page 565

NETGEAR 8800 Chassis Switch CLI Manual Default The default is 1. Usage Guidelines This is a paired command with configure ip-security anomaly-protection notify trigger off that configures an anomaly rate-based notification feature. The anomaly notification is automatically triggered if the rate of anomaly events is greater than the configured ON value, and the notification is disabled if the rate falls below the value set in the configure ip-security anomaly-protection notify trigger off command. The command takes effects after the anomaly notification is enabled. Note: The value set in ON must be greater than or equal to the value set in OFF. configure ip-security anomaly-protection tcp configure ip-security anomaly-protection tcp min-header-size {slot [ | all ]} Description Configures the minimum TCP header allowed. Syntax Description size Specifies the size of the header in bytes. slot Specifies the slot to be used. all Specifies all IP addresses, or all IP addresses in a particular state. Default The default value is 20 bytes. Usage Guidelines This command configures the minimum TCP header allowed. It takes effect for both IPv4 and IPv6 TCP packets. The range of the minimum TCP header may be between 8 and 255 bytes. configure ip-security dhcp-snooping information check configure ip-security dhcp-snooping information check Chapter 15. Security Commands | 565