Netgear XCM8806 Chassis Hardware Installation Guide - Page 1357
Additional Guidelines Applicable to NETGEAR 8800, Running Diagnostics, Example, Description
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1357 highlights
NETGEAR 8800 Chassis Switch CLI Manual Additional Guidelines Applicable to NETGEAR 8800 If you use the show diagnostics {slot [ | A | B]} command on a slot where diagnostics have not been run, the switch displays messages similar to the following: No Diagnostics Data or Diagnostics never run If you try to display diagnostic test information on a slot where no module is installed, the switch displays messages similar to the following: No Module Present or No card in slot Running Diagnostics To run diagnostics on an I/O module or an MSM installed in a NETGEAR 8800 series switch, use the following command: run diagnostics [extended | normal] {slot [ | A | B]} Depending on the software version running on your switch or your switch model, additional or different diagnostic information might be displayed. For more information, see the command run diagnostics on page 1352. Example The following command displays the results of module diagnostics for the I/O module in slot 2: show diagnostics slot 2 The following is sample output from a NETGEAR 8800 series switch: Slot-2: XCM8824F Last Test Date: Wed May 6 23:57:17 2009 Last Test Version: 12.3.0.1 Summary: Diagnostics Pass When the version is unknown, Last Test Version reads "Unknown." show forwarding configuration show forwarding configuration Description Displays the configured selection criteria for ECMP routes and load-sharing group ports and the hardware table settings, including the configured and current hash algorithm and dual-hash settings. Appendix B. Troubleshooting Commands | 1357