Netgear XCM8806 Chassis Hardware Installation Guide - Page 1336

NETGEAR 8800 Chassis Switch CLI Manual Syntax Description fname partition slotid reboot Specifies the software package to uninstall. Specifies which partition the package was installed to: primary or secondary. Select primary to remove it from the primary partition and secondary to remove it from the secondary partition. Specifies the MSM where the package should be uninstalled. • A specifies the MSM/MM installed in slot A. • B specifies the MSM/MM installed in slot B. Reboots the switch after the package is uninstalled. Default N/A. Usage Guidelines Use this command to uninstall a software package previously installed on the switch. When you uninstall a software package, the switch prompts you to save your changes to your currently active configuration file: Uninstallation of the EXOS module Do you want to save configuration changes to primary.cfg? (y or n) Enter y to save the changes to your configuration file. Enter n to not save the changes to your configuration file. Local Filename Character Restrictions This section provides information about the characters supported by the switch for local and remote filenames. When specifying a local filename, the switch permits only the following characters: • Alphabetical letters, upper case and lower case (A-Z, a-z) • Numerals (0-9) • Period ( . ) • Dash ( - ) • Underscore ( _ ) When naming a local file, remember the requirements previously described. Example The following command uninstalls the software package NG8800-12.4.3.5-1-4.xos from the secondary partition: uninstall image NG8800-12.4.3.5-1-4.xos secondary 1336 | Appendix A. Configuration and Image Commands