Netgear XCM8806 Chassis Hardware Installation Guide - Page 743
con mstp format
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 743 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command clears all of the STP domain, port, and diagnostic counters: clear counters stp configure mstp format configure mstp format Description Configures the number used to identify the MSTP BPDUs sent in the MSTP region. Syntax Description format_identifier Specifies a number that MSTP uses to identify all BPDUs sent in the MSTP region. The default is 0. The range is 0 to 255. Default The default value used to identify the MSTP BPDU is 0. Usage Guidelines For a switch to be part of an MSTP region, you must configure each switch in the region with the same MSTP configuration attributes, also known as MSTP region identifiers. These identifiers consist of the following: • Region Name-The name of the MSTP region. • Format Selector-The number used to identify the format of MSTP BPDUs. The default is 0. • Revision Level-This identifier is reserved for future use; however, the switch uses and displays a default of 3. You can configure only one MSTP region on the switch at any given time. The switches contained in a region transmit and receive BPDUs that contain information relevant to only that MSTP region. By having devices look at the region identifiers, MSTP discovers the logical boundary of a region. If you have an active MSTP region, NETGEAR recommends that you disable all active STPDs in the region before modifying the value used to identify MSTP BPDUs on all participating switches. Example The following command configures the number 2 to identify the MSTP BPDUs sent within an MSTP region: configure mstp format 2 Chapter 17. STP Commands | 743