Netgear XCM8806 Chassis Hardware Installation Guide - Page 207

NETGEAR 8800 Chassis Switch CLI Manual Example The following example adds port 3:13 to the LAG with the logical port 3:9 on the switch: configure sharing 3:9 add port 3:13 configure sharing address-based custom configure sharing address-based custom [ipv4 [L3-and-L4 | source-only | destination-only | source-and-destination] | hash-algorithm [xor | crc-16]] Description On NETGEAR 8800 series switches, this command configures the part of the packet examined by the switch when selecting the egress port for transmitting link aggregation, or load-sharing, data. Syntax Description ipv4 L3-and-L4 source-only destination-only source-and-destination xor crc-16 Specifies that the user configuration applies to IPv4 traffic. Indicates that the switch should examine the IP source and destination address and the TCP or UDP source and destination port number. Indicates that the switch should examine the IP source address only. Indicates that the switch should examine the IP destination address only. Indicates that the switch should examine the IP source and destination address. Use exclusive-OR for load sharing hash computation. Use CRC-16 for load sharing hash computation. Default Algorithm: L3-and-L4 Hash algorithm: xor Usage Guidelines This command specifies the part of the packet header that the switch examines to select the egress port for address-based load-sharing trunks. The address-based load-sharing setting is global and applies to all load-sharing trunks, or LAGs, that are address-based and configured with a custom algorithm. You change this setting by issuing the command again with a different option. The addressing information examined is based on the packet protocol as follows: • IPv4 packets-Uses the source and destination IPv4 addresses and Layer 4 port numbers as specified with this command. Chapter 5. Commands for Configuring Slots and Ports on a Switch | 207