Netgear XCM8806 Chassis Hardware Installation Guide - Page 1113
con bgp peer-group soft-reset
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1113 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command configures communities to be sent to neighbors as part of route updates: configure bgp peer-group outer send-community configure bgp peer-group soft-reset configure bgp peer-group {address-family [ipv4-unicast | ipv4-multicast]} soft-reset {in | out} Description Applies the current input/output routing policy to the neighbors in the peer group. Syntax Description peer-group-name ipv4-unicast ipv4-multicast in out Specifies a peer group. Specifies the address family IPV4 unicast Specifies the address family IPV4 multicast. Specifies to apply the input routing policy. Specifies to apply the output routing policy. Default N/A. Usage Guidelines The input/output routing policy is determined by the route policy configured for the neighbors in the peer group on the input/output side of the router. This command does not affect configuration of the switch. Changes made to the parameters of a peer group are applied to all neighbors in the peer group. Modifying the following parameters automatically disables and enables the neighbors before changes take effect: • remote-as • timer • source-interface • soft-in-reset • password Chapter 25. BGP Commands | 1113