3Com 5500G-EI Command Reference Guide - Page 107
ARP Configuration, Commands, Example, arp check enable, Syntax, Parameter, Description, arp static
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
ARP Configuration Commands 107 Example To enter a host name of Lanswitch1 for the IP address 202.38.0.8, enter the following . system-view System View: return to User View with Ctrl+Z. [SW5500]ip host Lanswitch1 202.38.0.8 ARP Configuration Commands This section describes the commands you can use to configure and manage the Address Resolution Protocol (ARP) operations on your Switch 5500G-EI. arp check enable Syntax arp check enable undo arp check enable View System View Parameter None Description Use the arp check enable command to enable the checking of an ARP entry so the device does not learn the ARP entry where the MAC address is a multicast MAC address. Use the undo arp check enable command to disable the checking of ARP entry so the device learns the ARP entry where the MAC address is a multicast MAC address. By default, the checking of ARP entry is enabled and the device does not learn the ARP entry where the MAC address is a multicast MAC address. Example Configure that the device learns the ARP entry where the MAC address is multicast MAC address. system-view System View: return to User View with Ctrl+Z. [SW5500]undo arp check enable arp static Syntax arp static ip_address mac_address [ vlan_id { interface_type | interface_number }] undo arp static ip_address View System View Parameters ip_address Enter the IP address of the ARP mapping entry.