Home » 3Com Manuals » Hubs & Switches » 3Com 5500G-EI » Manual Viewer

3Com 5500G-EI Command Reference Guide - Page 320

display stp ignored-vlan, Syntax, Parameter, Description, Example, display stp tc, reset stp

UPC - 662705493534

Add to My Manuals
Save this manual to your list of manuals

Page 320 highlights

324 CHAPTER 10: USING RSTP COMMANDS display stp ignored-vlan Syntax display stp ignored-vlan View Any view Parameter None Description Use the display stp ignored-vlan command to view the list of STP-Ignored VLANs. After a STP-Ignored VLAN is configured, the packets of this VLAN will be forwarded on any Switch port, with no restriction from the calculated STP path. Example To display the list of STP-Ignored VLANs, enter the following: display stp ignored-vlan STP-Ignored VLAN: 10, 20, 30, 40 display stp tc Syntax display stp tc View All views Parameter None Description Use the display stp tc command to display the number of topology changes and/or topology change notifications that an active port has recieved. Related command: reset stp. Example To display the number of topology changes and/or notifications , enter the following: display stp stc -------Stp port received--------- TC-----or----- TCN----count- reset stp Syntax reset stp [ interface interface_list ] View User view

Section	Page
About This Guide	19
Using System Access Commands	23
Using Port Commands	47
Using VLAN Commands	79
Using Power over Ethernet (PoE) Commands	91
Using Network Protocol Commands	101
Using Routing Protocol Commands	143
Using Multicast Protocol Commands	235
Using QoS/ACL Commands	281
Using RSTP Commands	317
Using Fabric Commands	337
Using AAA and RADIUS Commands	341
Using System Management Commands	397