3Com 5500G-EI Command Reference Guide - Page 502

502 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS display ntp-service Syntax sessions display ntp-service sessions [ verbose ] View All views. Parameter verbose: display detailed information about the sessions. Description Use the display ntp-service sessions command to display the status of all the sessions maintained by NTP service provided by the local equipment. By default, the status of all the sessions maintained by NTP service provided by the local equipment will be displayed. When you configure this command without the verbose parameter, the Switch will only display brief information about all the sessions it maintains. With the verbose parameter configured, the Switch will display detailed information about all the sessions it maintains. Example display ntp-service sessions The information displays in the following format: source refid st now poll reach delay offset disp [12345]212.125.95.4 131.188.3.221 2 18 64 377 339.8 10.8 0.9 note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured display ntp-service Syntax status display ntp-service status Views All views. Parameter None Description Use the command display ntp-service status to display the NTP service status. Example display ntp-service status The information displays in the following format: clock status: unsynchronized clock stratum: 16 reference clock ID: none nominal frequency: 100.0000 Hz