3Com 5500G-EI Command Reference Guide - Page 286

286 CHAPTER 8: USING QOS/ACL COMMANDS System View: return to User View with Ctrl+Z [SW5500]interface GigabitEthernet 1/0/1 [SW5500-GigabitEthernet1/0/1]packet-filter inbound ip-group 2000 reset acl counter Syntax reset acl counter { all | acl-number } View User View Parameter all: All ACLs. acl-number: Specifies an ACL by its number, ranging from 2000 to 4999. Description Use the reset acl counters command to reset the ACL statistics information to zero. Example Clear the statistics information of ACL 2000. reset acl counters 2000 rule Syntax Define or delete the subrules of a basic ACL: rule [ rule-id ] { permit | deny } [source { source-addr wildcard | any } fragment | time-range name ]* undo rule rule-id [ source | fragment | time-range ]* Define or delete the subrules of an advanced ACL: rule [ rule-id ] { permit | deny } protocol [ source { source-addr wildcard | any } ] [ destination { dest-addr wildcard | any } ] [ source-port operator port1 [ port2 ] ] [ destination-port operator port1 [ port2 ] ] [ icmp-type type code ] [ established ] [ [ { precedence precedence tos tos | dscp dscp }* | vpn-instance instance ] | fragment | logging | time-range name ]* undo rule rule-id [ source | destination | source-port | destination-port | icmp-type | precedence | tos | dscp | fragment | logging | time-range | vpn-instance ]* Define or delete the subrules of a Layer 2 ACL: rule [ rule-id ] { permit | deny } [ [ type protocol-type type-mask | lsap lsap-type type-mask ] | format-type | cos cos | source { source-vlan-id | source-mac-addr source-mac-wildcard }* | dest { dest-mac-addr dest-mac-wildcard } | time-range name ]* undo rule rule-id