3Com 5500G-EI Command Reference Guide - Page 135

IP Performance Configuration Commands 135 timestamp 0 mask requests 0 time exceeded 0 Output:echo 10 source quench 0 echo reply 5 timestamp 0 mask requests 0 time exceeded 0 information request 0 mask replies 0 destination unreachable 0 redirects 0 parameter problem 0 information reply 0 mask replies 0 Table 13 Output Description of the display icmp statistics Command Field bad formats bad checksum echo destination unreachable source quench redirects echo reply parameter problem timestamp information request mask requests mask replies information reply time exceeded Description Number of input packets in bad format Number of input packets with wrong checksum Number of input/output echo request packets Number of input/output packets with unreachable destination Number of input/output source quench packets Number of input/output redirected packets Number of input/output echo reply packets Number of input/output packets with parameter problem Number of input/output timestamp packets Number of input information request packets Number of input/output mask request packets Number of input/output mask reply packets Number of output information reply packets Number of time exceeded packets display ip socket Syntax display ip socket [ socktype sock-type ] [ task-id socket-id ] View Any View Parameters sock-type Enter the type of a socket: (tcp:1, udp 2, raw ip 3). task-id Enter the ID of a task, with the value ranging from 1 to 100. socket-id Enter the ID of a socket, with the value ranging from 0 to 3072. Description Use the display ip socket command to display the information about the sockets in the current system. Example To display the information about the socket of TCP type, enter the following: display ip socket socktype 1 SOCK_STREAM: Task = VTYD(18), socketid = 1, Proto = 6,