3Com 5500G-EI Command Reference Guide - Page 421

FTP Client Commands 421 ftp: Specifies the user's service type as FTP. ftp-directory directory: Enter an FTP directory, up to 64 characters in length. Optional. lan-access: Specifies user type to lan-access, which mainly refers to Ethernet accessing users, 802.1x supplicants for example. terminal: Authorizes the user to use the terminal service (login from the Console, AUX or Asyn port). Description Use the service-type command to configure a service type for a particular user. Use the undo service-type command to cancel the currently configured service type for a particular user. If configuring service types: SSH, Telnet or Terminal: When you configure a new service type for a user, the system adds the new service type to the existing one. You can set user level when you configure a service type. If you set multiple service types and specify the user levels, then only the last configured user level is valid. Different service type does not have its individual user level. You can use either level or service-type command to specify the level for a local user. If both of these two commands are used, the latest configuration will take effect. Example To configure a service type of LAN access for the user guest, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]local-user-guest [SW5500-luser-guest]service-type lan-access FTP Client Commands This section describes the File Transfer Protocol (FTP) Client commands on your Switch 5500G-EI. ascii Syntax ascii View FTP Client view Parameter None Description Use the ascii command to configure data transmission mode as ASCII mode.