Home » 3Com Manuals » Hubs & Switches » 3Com 5500G-EI » Manual Viewer

3Com 5500G-EI Command Reference Guide - Page 447

System Debug, Commands, display debugging, Syntax, Parameter, Description, Example, display version

UPC - 662705493534

Add to My Manuals
Save this manual to your list of manuals

Page 447 highlights

System Debug Commands 447 display debugging Syntax display debugging [ interface { interface-name | interface-type interface-num } ] [ module-name ] View All views Parameter interface-name: Specify the Ethernet port name. interface-type: Specify the Ethernet port type. interface-num: Specify the Ethernet port number. module-name: Specify the module name. Description Use the display debugging command to display the enabled debugging process. Show all the enabled debugging when there is no parameter. For the related commands, see debugging. Example Show all the enabled debugging. display debugging IP packet debugging switch is on. display version Syntax display version View All views Parameter None Description Use the display version command to view the software version, issue date and the basic hardware configuration information. Example Display the information about the system version. display version System Debug Commands This section describes the system debugging options, and the system diagnostics information that can be displayed on your Switch 5500G-EI.

Section	Page
About This Guide	19
Using System Access Commands	23
Using Port Commands	47
Using VLAN Commands	79
Using Power over Ethernet (PoE) Commands	91
Using Network Protocol Commands	101
Using Routing Protocol Commands	143
Using Multicast Protocol Commands	235
Using QoS/ACL Commands	281
Using RSTP Commands	317
Using Fabric Commands	337
Using AAA and RADIUS Commands	341
Using System Management Commands	397