3Com 5500G-EI Command Reference Guide - Page 290
QoS Configuration, Commands List, Description, Example, display mirror, Syntax, Parameter
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 290 highlights
290 CHAPTER 8: USING QOS/ACL COMMANDS to end-time end-date:: The end date of a special time-range, together with start-time start-date means this special time-range is effective during a certain period, notated as hh:mm MM/DD/YYYY. If the above two parameters are not configured, it means there is no restriction to time-range. Description Use the time-range command to configure a time range. Use the undo time-range command to delete a time range. If you input the parameter when using the undo time-range command, the system will cancel the corresponding content of the parameters in the time range. Example Configure a time range to take effect at 00:00 on January 1, 2000 with no end date specified. system-view System View: return to User View with Ctrl+Z [SW5500]time-range test from 0:0 1-1-2000 QoS Configuration Commands List This section describes how to use the Quality of Service (QoS) configuration commands on your Switch 5500G-EI. display mirror Syntax display mirror View Any view Parameter None Description Use the display mirror command to view port mirroring configuration, including monitored ports, monitor port and monitor direction, and so on. Related commands: mirroring-port, monitor-port. Example To display the port mirroring configuration, enter the following: system-view System View: return to User View with Ctrl+Z [SW5500] display mirror Monitor-port: GigabitEthernet1/0/1 Mirroring-port: GigabitEthernet1/0/2 both