3Com 5500G-EI Command Reference Guide - Page 287
Parameter, Parameters specific to basic ACLs, Corresponding ACL View
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 287 highlights
ACL Configuration Command List 287 View Corresponding ACL View Parameter rule-id: Specifies the subitems of an ACL, ranging from 0 to 65534. permit: Permits packets that meet the requirements. deny: Denies packets that meet the requirements. time-range name: Name of a time range, during which a rule takes effect. The following parameters are various property parameters carried by packets. The ACL sets rules according to this parameter. Parameters specific to basic ACLs: source { source-addr wildcard | any }: source-addr wildcard represents the source IP address and the wildcard digit represented in dotted decimal notation. any represents all source addresses. fragment: Means this rule is only effective fragment packets and is ignored for non-fragment packets. logging Parameters specific to advanced ACLs: protocol: Specifies the protocol type which is represented by a name or a number. When it is a name, this parameter can be adopted like: icmp, igmp, tcp, udp, ip, gre, ospf, ipinip, etc. If the adopted value is IP, that means all the Internet Protocols. When it is a number: it ranges from 1 to 225. source { source-addr wildcard | any }: source-addr wildcard means the source IP address and the wildcard digit represented in dotted decimal notation. any means all source addresses. destination { dest-addr wildcard | any }: dest-addr wildcard means the destination IP address and the wildcard digit represented in dotted decimal notation. any means all destination addresses. source-port operator port1 [port2]: Source port number of TCP or UDP used by the packet. operator is port operator, including eq (equal), gt (greater than), lt (less than),neq (not-equal), range (within this range). Note that this parameter is only available when the parameter protocol is TCP or UDP. port1 [port2]: Source port number of TCP or UDP used by the packet, notated by a character or a number which ranges from 0 to 65535 inclusive. For the value of the character, please refer to mnemonic symbol table. The two parameters port1 and port2 appear at the same time only when the operator is "range", but other operators need "port1" only. destination-port operator port1 [port2]: Destination port number of TCP or UDP used by packets. For detailed description, please refer to source-port operator port1 [port2].