3Com 5500G-EI Command Reference Guide - Page 347
Parameter, Description, Example, dot1x port-control, Syntax
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
802.1x Configuration Commands 347 Parameter user-number: Specifies the limit to the amount of supplicants on the port, ranging from 1 to 1024. By default, the maximum user number is 1024. interface interface-list: Ethernet interface list including several Ethernet interfaces, expressed in the format interface-list = { interface-num [ to interface-num ] } & < 1-10 >. interface-num specifies a single Ethernet interface in the format interface-num = { interface-type interface-num | interface-name }, where interface-type specifies the interface type, interface-num specifies the interface number and interface-name specifies the interface name. For the respective meanings and value ranges, see the parameters in the Port Command chapter. Description Use the dot1x max-user command to configure a limit to the amount of supplicants on the specified interface using 802.1x. Use the undo dot1x max-user command to restore the default value. This command is used for setting a limit to the amount of supplicants that 802.1x can hold on the specified interface. This command takes effect on the interface specified by the parameter interface-list when executed in System View. It takes effect on all the interfaces when no interface is specified. The parameter interface-list cannot be entered when the command is executed in Ethernet Port View and it takes effect only on the current interface. Related command: display dot1x. Example Configure the interface GigabitEthernet 1/0/1 to hold no more than 32 users. system-view System View: return to User View with Ctrl-Z [SW5500]dot1x max-user 32 interface gigabitethernet 1/0/1 dot1x port-control Syntax dot1x port-control { auto | authorized-force | unauthorized-force-} [ interface interface-list ] undo dot1x port-control [ interface interface-list ] View Ethernet Port View Parameter auto: Automatic identification mode, configuring the initial state of the interface as unauthorized. The user is only allowed to receive or transmit EAPoL packets but not to access the network resources. If the user passes the authentication flow, the interface will Switch over to the authorized state and then the user is allowed to access the network resources. This is the most common case.