3Com 5500G-EI Command Reference Guide - Page 378

378 CHAPTER 11: USING AAA AND RADIUS COMMANDS Code= 5,Num=0 Code=11,Num=0 Code=22,Num=0 ,Err=0 ,Err=0 ,Err=0 Running statistic: RADIUS received messages statistic: Normal auth request ,Num=0 EAP auth request ,Num=0 Account request ,Num=0 Account off request ,Num=0 Leaving request ,Num=0 ,Err=0 ,Err=0 ,Err=0 ,Err=0 ,Err=0 ,Succ=0 ,Succ=0 ,Succ=0 ,Succ=0 ,Succ=0 display stop-accounting-buffer Syntax display stop-accounting-buffer { radius-scheme radius-scheme-name | session-id session-id | time-range start-time stop-time | user-name user-name } View All views Parameter radius-scheme radius-scheme-name: Configures to display the saved stopping accounting requests according to RADIUS server name. radius-scheme-name specifies the RADIUS server name with a character string not exceeding 32 characters. session-id session-id: Configures to display the saved stopping accounting requests according to the session ID. session-id specifies the session ID with a character string not exceeding 50 characters. time-range start-time stop-time: Configures to display the saved stopping accounting requests according to the saving time. Start-time specifies the start time of the saving time range and stop-time specifies the stop time of the saving time range. The time is expressed in the format hh:mm:ss-yyyy/mm/dd. When this parameter is specified, all the stopping accounting requests saved in the time range since start-time to stop-time will be displayed. user-name user-name: Configures to display the saved stopping accounting requests according to the username. User-name specifies the username, a character string not exceeding 32 characters,. The @ character can only be used once in one username. The pure username (the part before @, namely the user ID) cannot exceed 24 characters. Description Use the display stop-accounting-buffer command to view the stopping accounting requests, which have not been responded and saved in the buffer. After transmitting the stopping accounting requests, if there is no response from the RADIUS server, the Switch will save the packet in the buffer and retransmit it for several times, which is set through the retry realtime-accounting. This command is used to display the stopping accounting requests saved in the Switch buffer. You can select to display the packets sent to a certain RADIUS