3Com 5500G-EI Command Reference Guide - Page 291

QoS Configuration Commands List 291 display qos-interface all Syntax display qos-interface { interface-name | interface-type interface-num | unit-id } all View All views Parameter interface-name | interface-type interface-num: Interfaces of the Switch. For more information, refer to the port command in this manual. unit-id: Unit ID of the Switch. Description Using the display qos-interface { interface-name | interface-type interface-num | unit-id } all command, you can view QoS information of all interfaces. If you do not input interface parameters, this command will display all QoS setting information for the Switch, including traffic policing, rate limit at interface, and so on. If you input interface parameters, this command will display QoS setting information of the specified interfaces, including traffic policing, rate limit at interfaces, and so on. Example Display all the configurations of QoS parameters for unit 1. display qos-interface 1 all GigabitEthernet1/0/1: traffic-limit Inbound: Matches: Acl 2000 rule 1 running Target rate: 128 Kbps GigabitEthernet1/0/1: traffic-priority Inbound: Matches: Acl 2000 rule 1 running Priority action: cos best-effort GigabitEthernet1/0/1: line-rate Outbound: 128 Kbps GigabitEthernet1/0/1: traffic-statistic Queue scheduling mode: weighted round robin weight of queue 1: 1 weight of queue 2: 2 weight of queue 3: 3 weight of queue 4: 4 weight of queue 5: 5 weight of queue 6: 6 ---- More ---- display qos-interface line-rate Syntax display qos-interface { interface-name | interface-type interface-num | unit-id } line-rate