3Com 5500G-EI Command Reference Guide - Page 219
Parameter, Description, Example, vlink-peer, Syntax
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
OSPF Configuration Commands 219 View OSPF Area view Parameter no-summary Enter to prevent the transmission of Summary LSAs to the Stub area. Description Using the stub command, you can configure the type of an OSPF area as "stub". Using the undo stub command, you can cancel the setting. By default, no OSPF areas are set as Stub areas. If the router is an ABR, it will send a default route to the connected stub area. Using the default-cost command, you can configure the default route cost. Related commands:default-cost. Example To set the type of OSPF area 1 to Stub, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]router id 1.1.1.1 [SW5500]ospf [SW5500-ospf]area 1 [SW5500-ospf-1-area-0.0.0.1]stub vlink-peer Syntax vlink-peer router_id [ hello seconds | retransmit seconds | trans-delay seconds | dead seconds | simple password | md5 keyid key ]* undo vlink-peer router-id View OSPF Area view Parameter router_id Enter the Router ID of a virtual link neighbor. hello seconds Enter the interval for the transmission of hello packets, in the range 1 to 8192 seconds. This must equal the hello seconds value of the router virtually linked to the interface. The default value is 10 seconds. retransmit seconds Enter the interval for the retransmission of LSA packets on an interface, in the range 1 to 8192 seconds. The default value is 5 seconds. trans-delay seconds Enter the delay interval for transmitting LSA packets on an interface, in the range 1 to 8192 seconds. The default value is 1 second. dead seconds Enter the dead time interval, in the range 1 to 8192 seconds. This value must equal the dead time of the virtually linked router, and must be at least four times that of the hello interval. The default value is 40 seconds.