3Com 5500G-EI Command Reference Guide - Page 264
Parameter, Description, Example, Syntax, advertised as a candidate RP address.
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 264 highlights
264 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS Parameter interface-type interface-number: Interface type and interface number of a router. The candidate BSR is configured on the interface. PIM-SM must be enabled on the interface first. hash-mask-len: Length of the mask. The value ranges from 0 to 32. priority: Priority of the candidate BSR. The larger the value of the priority, the higher the priority of the BSR. The value ranges from 0 to 255. The default value is 0. Description Use the c-bsr to configure a candidate BSR. Use the undo c-bsr to remove the candidate BSR configured. By default, no candidate BSR is set. Related command: pim sm. Example Configure the Ethernet Switch as C-BSR with priority 2 (and the C-BSR address is designated as the IP address of VLAN-interface10). system-view System View: return to User View with Ctrl+Z [SW5500]multicast routing-enable [SW5500] pim [SW5500-pim]c-bsr vlan-interface 10 24 2 c-rp Syntax c-rp interface-type interface-number [ group-policy acl-number | priority priority-value ]* undo c-rp {interface-type interface-number | all } View PIM View Parameter interface-type interface-number: Specified interface with the IP address advertised as a candidate RP address. acl-number: Number of the basic ACL that defines a group range, which is the service range of the advertised RP. The value ranges from 2000 to 2999. priority-value: Priority value of candidate RP, in the range of 0 to 255. By default, it is 0. The greatest value corresponds to the lowest priority level. all: Remove all candidate RP configurations. Description Use the c-rp to configure the router to advertise itself as a candidate RP.