3Com 5500G-EI Command Reference Guide - Page 55
Description, Example, duplex, Syntax, Parameters
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Ethernet Port Configuration Commands 55 Description Using display unit unit-id interface command, you can view all port interfaces for the specified unit. Example Display the port information for all ports on Unit 1. display unit 1 interface Aux1/0/0 current state :DOWN Line protocol current state :DOWN Internet protocol processing : disabled Description : Aux1/0/0 Interface The Maximum Transmit Unit is 1500 Data drive mode: interactive 5 minutes input rate 0.0 bytes/sec, 0.0 packets/sec 5 minutes output rate 0.0 bytes/sec, 0.0 packets/sec 0 packets input, 1000 bytes 0 packets output, 27317 bytes error: Parity 0, Frame 0, Overrun 0, FIFO 0 DCD=UP DTR=UP DSR=UP RTS=UP CTS=UP Cascade1/2/1 current state :DOWN Line protocol current state :DOWN Description : Cascade1/2/1 Interface The Maximum Transit Unit is 1500, Hold timer is 10(sec) (Omitted) duplex Syntax duplex { auto | full | half } undo duplex View Ethernet Port View Parameters auto: Enter to set the port to auto-negotiation. full: Enter to set the port to full-duplex. half: Enter to set the port to half-duplex. Description Use the duplex command to configure the duplex mode of an Ethernet port to auto-negotiation, full duplex or half-duplex. Use the undo duplex command to restore the duplex mode of a port to the default mode (auto-negotiation). Related command: speed. Example To configure the Ethernet port "Ethernet1/0/1" to auto-negotiation, enter the following: system-view