3Com 5500G-EI Command Reference Guide - Page 172
rip metricout, Syntax, Parameter, Description, Example, rip output
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
172 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS [SW5500]interface Vlan-interface 1 [SW5500-Vlan-interface1]rip metricin 2 rip metricout Syntax rip metricout value undo rip metricout View Interface View Parameter value Enter an additional route metric added when transmitting a packet, ranging from 1 to 16. By default, the value is 1. Description Use the rip metricout command to configure an additional route metric to be added to a route when an interface transmits RIP packets. Use the undo rip metricout command to restore the default value of the additional route metric. Related command: rip metricin. Example To set the additional route metric to 2 when the interface Vlan-interface 1 transmits RIP packets, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]interface Vlan-interface 1 [SW5500-Vlan-interface1]rip metricout 2 rip output Syntax rip output undo rip output View Interface View Parameter None Description Use the rip output command to allow an interface to transmit RIP packets. Use the undo rip output command to disable an interface from transmitting RIP packets. By default, all interfaces except loopback interfaces are able to transmit RIP packets.