Home » 3Com Manuals » Hubs & Switches » 3Com 5500G-EI » Manual Viewer

3Com 5500G-EI Command Reference Guide - Page 114

Example, resilient-arp interface, vlan-interface, Syntax, Parameter, Description

UPC - 662705493534

Add to My Manuals
Save this manual to your list of manuals

Page 114 highlights

114 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS Example To enable the resilient ARP function, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]resilient-arp enable resilient-arp interface Syntax vlan-interface resilient-arp interface vlan-interface vlan-id undo resilient-arp interface vlan-interface vlan-id View System View Parameter vlan-id Enter the VLAN interface ID. Description Use the resilient-arp interface vlan-interface command to configure the Switch to send resilient ARP packets out the specified VLAN interface. Use the undo resilient-arp interface vlan-interface command to stop the Switch from sending ARP packets out of the specified VLAN interface. By default, the system sends resilient ARP packets out of VLAN interface 1. For the related command, see display resilient-arp. Example To set VLAN interface 2 to send resilient ARP packets., enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]resilient-arp interface vlan-interface 2

Section	Page
About This Guide	19
Using System Access Commands	23
Using Port Commands	47
Using VLAN Commands	79
Using Power over Ethernet (PoE) Commands	91
Using Network Protocol Commands	101
Using Routing Protocol Commands	143
Using Multicast Protocol Commands	235
Using QoS/ACL Commands	281
Using RSTP Commands	317
Using Fabric Commands	337
Using AAA and RADIUS Commands	341
Using System Management Commands	397