3Com 5500G-EI Command Reference Guide - Page 300
queue-scheduler, Syntax, Parameter, Description, Example, reset traffic-statistic
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 300 highlights
300 CHAPTER 8: USING QOS/ACL COMMANDS [SW5500-GigabitEthernet1/0/1]priority trust [SW5500-GigabitEthernet1/0/1] queue-scheduler Syntax queue-scheduler { wrr queue1-weight queue2-weight queue3-weight queue4-weight queue5-weight queue6-weight queue7-weight queue8-weight undo queue-scheduler View Ethernet Port View Parameter wrr queue1-weight queue2-weight queue3-weight queue4-weight queue5-weight queue6-weight queue7-weight queue8-weight: Indicates that the queue uses weight round robin (WWR) scheduling. queue1-weight: the weight of queue 1, the percentage allocated by bandwidth; queue2-weight: the weight of queue 2, and so on. The weight ranges from 0 to 15. Description Use the queue-scheduler command to configure queue scheduling mode. Use the undo queue-scheduler command to restore the default value. By default, WRR algorithm is selected for all outbound queues at a port. The queue weight is based on bytes. For example, if the weight of queues 1, 2, 3, 4, 5, 6, 7, 8 is respectively as 1, 2, 3, 4, 5, 6, 7, 8, then among every 36 bytes in process, 1 byte from queue 1, 2 bytes from queue 2, 3 bytes from queue 3, 4 bytes from queue 4, 5 bytes from queue 5, 6 bytes from queue 6, 7 bytes from queue 7 and 8 bytes from queue 8. Related configuration: display queue-scheduler. Example To set wrr as the port queue scheduling mode, enter the following: system-view System View: return to User View with Ctrl+Z [SW5500]queue-scheduler wrr 1 2 3 4 5 6 7 8 The queue scheduling parameters in all interfaces are refreshed. reset traffic-statistic reset traffic-statistic inbound { ip-group acl-number [ rule rule ] | link-group acl-number [ rule rule ] } View Ethernet Port View