3Com 5500G-EI Command Reference Guide - Page 41
Parameter, Description, Example, super, Syntax, enter a valid password
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Logging in Commands 41 undo stopbits View User interface view Parameter 1: Sets the stop bits to 1. 1.5: Sets the stop bits to 1.5. 2: Sets the stop bits to 2. Description Use the stopbits command to configure the stop bits on the AUX (Console) port. Use the undo stopbits command to restore the default stop bits (the default is 1). This command can only be performed in AUX user interface view. Example To configure the stop bits to 2, enter the following from the AUX (Console) port: system-view System View: return to User View with Ctrl+Z. [SW5500]user-interface aux 0 [SW5500-ui-aux0]stopbits 2 super Syntax super level View All views Parameter level: Enter a user level in the range 0 to 3. The default is 3. Description The super command gives a user access to a higher level than their currently assigned user level. To ensure that only an authorized user can access the higher level, use the super password command to set a password for the higher level. If the user does not enter a valid password, the user level does not change. Login users are classified into four levels that correspond to the four command levels. A user can only use commands at the levels that are equal to or lower than their user level. Related commands: super password, quit. Example To change to user level 3 from the current user level.