3Com 5500G-EI Command Reference Guide - Page 276
Example, register-policy, Syntax, Parameter, Description, reset pim neighbor, All PIM neighbors
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 276 highlights
276 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS Example Configure to transmit Hello packet via VLAN-interface10 every 40 seconds. system-view System View: return to User View with Ctrl+Z [SW5500]multicast routing-enable [SW5500]interface Vlan-interface-10 [SW5500-vlan-interface10]pim timer hello 40 register-policy Syntax register-policy acl-number undo register-policy View PIM View Parameter acl-number: Number of IP advanced ACL, defining the rule of filtering the source and group addresses. The value ranges from 3000 to 3999. Description Use the register-policy command to configure a RP to filter the register messages sent by the DR in the PIM-SM network and to accept the specified messages only. Use the undo register-policy command to remove the configured message filtering. Example If the local device is the RP in the network, use the following command to only accept multicast message register of the source sending multicast address in the range of 225.1.0.0/16 on network segment 10.10.0.0/16. system-view System View: return to User View with Ctrl+Z [SW5500] acl number 3010 [SW5500-acl-adv-3010] rule permit ip source 10.10.0.0 0.0.255.255 destination 225.1.0.0 0.0.255.255 [SW5500-acl-adv-3010] quit [SW5500] pim [SW5500-pim] register-policy 3010 reset pim neighbor Syntax reset pim neighbor { all | { neighbor-address | interface interface-type interface-number} * } View User View Parameter all: All PIM neighbors