3Com 5500G-EI Command Reference Guide - Page 44
Parameter, Description, Example, user-interface, Syntax - default ip address
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
44 CHAPTER 1: USING SYSTEM ACCESS COMMANDS Parameter hostname: Enter the host name of the remote Switch. It is configured using the ip host command. ip_address: Enter the IP address or the host name of the remote Switch. If you enter the host name, the Switch must be set to static resolution. service_port: Designates the management port on the remote Switch, in the range 0 to 65535. Optional. Description Use the telnet command to log in to another Ethernet switch from the current switch via Telnet for remote management. To terminate the Telnet logon, press . If you do not specify a service_port, the default Telnet port number of 23 is used. Related command: display tcp status. Example To log in to the Ethernet switch Switch32 at IP address 10.1.1.1 from the current Switch (Switch01), enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]user-interface vty 0 4 [SW5500-ui-vty0-4]authentication-mode none telnet 10.1.1.1 Trying 10.1.1.1..... Press CTRL+K to abort Connected to 10.1.1.1... * All rights reserved (1997-2005) * * Without the owner's prior written consent, * *no decompiling or reverse-engineering shall be allowed.* user-interface Syntax user-interface [ type ] first_number [ last_number ] View System view Parameter type: Enter the user interface type, which can be aux or vty. first_number: Specifies the number of the first user interface to be configured.. last_number: Specifies the number of the last user interface to be configured.