3Com 5500G-EI Command Reference Guide - Page 73

Ethernet Port Link Aggregation Commands 73 Description Use the display link-aggregation interface command to view detailed link aggregation information at a designated port, including aggregation group ID for the port, port priority, operation key, LACP state flag, partner information (system ID, port number, port priority, operation key, LACP state flag, LACP packet statistics). Note that unlike a dynamic aggregation, a manual aggregation has no protocol to get the remote peer information of the partner. Therefore, every item for the remote peer is 0. This does not indicate the actual state of the remote peer. Example To display detailed link aggregation information of a link aggregation member port, enter the following: display link-aggregation interface Gigabitethernet4/0/1 If the aggregation has been created manually, the display will be similar to the following: GigabitEthernet4/0/1: Attached AggID: 1 Local: Port-Priority: 32768, Oper key: 1, Flag: 0x00 Remote: System ID: 0x0, 0000-0000-0000 Port Number: 0, Port-Priority: 0, Oper-key: 0, Flag: 0x00 If the aggregation is static or dynamic, the display will be similar to the following: display link-aggregation interface Gigabitethernet4/0/1 GigabitEthernet1/0/1: Attached AggID: 20 Local: Port-Priority: 32768, Oper key: 2, Flag: 0x3d Remote: System ID: 0x8000, 000e-84a6-fb00 Port Number: 2, Port-Priority: 32768 , Oper-key: 10, Flag: 0x3d Received LACP Packets: 8 packet(s), Illegal: 0 packet(s) Sent LACP Packets: 9 packet(s) Related command: display link-aggregation verbose. display lacp system-id Syntax display lacp system-id View Any view Parameter None