3Com 5500G-EI Command Reference Guide - Page 231
Route Capacity, Configuration, Commands, display memory, Syntax, Parameter, Description, Example
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
Route Capacity Configuration Commands 231 Route Capacity Configuration Commands This section describes the commands you can use to configure route capacity on the Switch. display memory Syntax display memory [ unit unit-id ] Mode Any View Parameter unit-id Enter the unit ID. Description Use the display memory command to view the memory setting. Example To display the current memory setting, enter the following: display memory Unit 1 System Available Memory(bytes): 92412672 System Used Memory(bytes): 25011700 Used Rate: 27% The displayed information is defined in Table 41. Table 41 Output Description of the display memory Command Item Unit 1 System Total Memory(bytes) Total Used Memory(bytes) Used Rate Description Display the memory information of unit 1. The total number of the Switch memory in bytes. The total number of the used Switch memory in bytes. The used rate of the Switch memory. display memory limit Syntax display memory limit Mode All Views Parameter None Description Use the display memory limit command to display the memory setting and state information related to the Ethernet switch capacity, including available memory and state information about connections, such as times for disconnecting connections, times for reestablishing connections, and the current state of the system.