3Com 5500G-EI Command Reference Guide - Page 200
display ospf vlink, Syntax, Parameter, Description, Example, Table 37
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
200 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS Table 37 Output Description of the display ospf routing Command Field Destination Cost Type NextHop AdvRouter Area Intra Area Inter Area ASE NSSA Description Destination of network segment Cost of route Type of route Next hop of route Router ID of the router advertising the route Area ID Number of intra-area routes Number of inter-area routes Number of external routes Number of NSSA routes display ospf vlink Syntax display ospf [ process-id ] vlink View All Views Parameter process-id: Enter the process ID of OSPF, ranging from 1 to 65535. The command is applied to all current OSPF processes if you do not specify a process ID. Description Use the display ospf vlink command to view the information about OSPF virtual links. Example To view OSPF virtual links information, enter the following: display ospf vlink OSPF Process 1 with Router ID 1.1.1.1 The information displays in the following format: Virtual links Virtual-link Neighbor-id -> 2.2.2.2, State: Full Cost: 0 State: Full Type: Virtual Transit Area: 0.0.0.2 Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1 Table 38 Output Description of the display ospf vlink Command Field Virtual-link Neighbor-id State Interface Description Router ID of virtual-link neighbor router State IP address of the interface on the virtual link