3Com 5500G-EI Command Reference Guide - Page 203

OSPF Configuration Commands 203 undo import-route protocol View OSPF View Parameter protocol Enter the source routing protocol to be imported. This can be one of the following: direct, rip, and static. route-policy route_policy_name Enter a route policy name. Only routes that match the specified route policy are imported. cost value Enter the cost of the imported route. type value Enter the cost type of imported routes. The value can be 1 or 2. The default value is 2. tag value Enter the tag value for imported external routes. Description Using the import-route command, you can import the external routing information of another routing protocol. Using the undo import-route command, you can cancel the import of external routing information. By default, the routing information of other protocols is not imported. 3Com recommends that you configure the route type, cost, and tag together in one command; otherwise, the new configuration overwrites the old one. Example To configure an imported RIP route with the external route of type 2, a route tag of 33 and a route cost of 50, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]router id 1.1.1.1 [SW5500]ospf [SW5500-ospf-1]import-route rip type 2 tag 33 cost 50 network Syntax network ip_address ip_mask undo network ip_address ip_mask View OSPF Area view Parameter ip_address Enter the IP address of the network segment where the interface is located.