3Com 5500G-EI Command Reference Guide - Page 62
port hybrid pvid vlan, Syntax, Parameter, Description, Example, port hybrid vlan - map
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
62 CHAPTER 2: USING PORT COMMANDS System View: return to User View with Ctrl+Z. [SW5500]interface Gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]port access vlan 3 port hybrid pvid vlan Syntax port hybrid pvid vlan vlan_id undo port hybrid pvid View Ethernet Port View Parameter vlan_id: Enter a VLAN ID in the range 2 to 4094, as defined in IEEE 802.1Q. The default is 1. Description Use the port hybrid pvid vlan command to configure the default VLAN ID of the hybrid port. Use the undo port hybrid pvid command to restore the default VLAN ID of the hybrid port. Hybrid port can be configured together with the isolate-user-vlan. But if the default VLAN has set mapping in the isolate-user-vlan, the default VLAN ID cannot be modified. If you want to modify it, cancel the mapping first. The default VLAN ID of local hybrid port must be consistent with that of the peer one, otherwise, the packets cannot be properly transmitted. Related command: port link-type. Example To configure the default VLAN of the hybrid port Ethernet1/0/1 to VLAN100, enter the following. system-view System View: return to User View with Ctrl+Z. [SW5500]interface Gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]port hybrid pvid vlan 100 port hybrid vlan Syntax port hybrid vlan vlan_id_list { tagged | untagged } undo port hybrid vlan vlan_id_list View Ethernet Port View