3Com 5500G-EI Command Reference Guide - Page 168
Parameter, Description, Example, reset, Syntax
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
168 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS Parameter value Enter the preference level, in the range 1 to 255. By default, the value is 100. Description Use the preference command to configure the route preference of RIP. Use the undo preference command to restore the default preference. The default value of each routing protocol is determined by the specific routing policy. This "preference" determines the optimal route in the IP routing table. You can use this command to modify the RIP preference. Example To specify an RIP preference of 20, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]rip [SW5500-rip]preference 20 reset Syntax reset View RIP view Parameter None Description Use the reset command to reset the system configuration parameters of RIP. When you need to re-configure parameters of RIP, this command can be used to restore to the default setting. Example Reset the RIP system. system-view System View: return to User View with Ctrl+Z. [SW5500]rip [SW5500-rip]reset rip Syntax rip undo rip View System View