Home » 3Com Manuals » Hubs & Switches » 3Com 5500G-EI » Manual Viewer

3Com 5500G-EI Command Reference Guide - Page 422

Example, binary, Syntax, Parameter, Description, FTP Client view

UPC - 662705493534

Add to My Manuals
Save this manual to your list of manuals

Page 422 highlights

422 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS By default, the file transmission mode is ASCII mode. Perform this command if the user needs to change the file transmission mode to default mode. Example Configure to transmit data in the ASCII mode. [ftp]ascii 200 Type set to A. binary Syntax binary View FTP Client view Parameter None Description Use the binary command to configure file transmission type as binary mode. Example Configure to transmit data in the binary mode. [ftp]binary 200 Type set to I. bye Syntax bye View FTP Client view Parameter None Description Use the bye command to disconnect with the remote FTP Server and return to user view. After performing this command, you can terminate the control connection and data connection with the remote FTP Server. Example Terminate connection with the remote FTP Server and return to user view. [ftp]bye cd Syntax cd pathname

Section	Page
About This Guide	19
Using System Access Commands	23
Using Port Commands	47
Using VLAN Commands	79
Using Power over Ethernet (PoE) Commands	91
Using Network Protocol Commands	101
Using Routing Protocol Commands	143
Using Multicast Protocol Commands	235
Using QoS/ACL Commands	281
Using RSTP Commands	317
Using Fabric Commands	337
Using AAA and RADIUS Commands	341
Using System Management Commands	397