3Com 5500G-EI Command Reference Guide - Page 72
Description, Example, display, link-aggregation, interface, Syntax, Parameter - manual com
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
72 CHAPTER 2: USING PORT COMMANDS Description Use the display link-aggregation verbose command to view detailed information of a link aggregation, including aggregation ID, the type of aggregation, load-sharing type, detailed local information (member ports, port status, port priority, LACP state flag and operation key), and detailed remote information (indexes of remote ports, port priority, LACP state flag, operation key and system ID.) Note that unlike a dynamic aggregation, a manual aggregation has no protocol to get the remote peer information of the partner. Therefore, every item for the remote peer is 0. This does not indicate the actual state of the remote peer. Example To display detailed information of aggregation group 1, enter the following: display link-aggregation verbose 1 Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing Aggregation ID: 1, AggregationType: Manual, Loadsharing Type: NonS Aggregation Description: System ID: 0x8000, 0e0-fcff-ff04 Port Status: S -- Selected, T -- Standby Local: Port Status Priority Flag Oper-Key GigabitEthernet1/0/3 S 32768 0x3d Remote: Actor Partner Priority Flag Oper-Key SystemID GigabitEthernet1/0/3 32768 0x3d3 0 0x8000,00e0-fcff-ff01 display link-aggregation interface Syntax display link-aggregation interface { interface_type interface_number | interface_name } [ to { interface_type interface-num | interface_name } ] View Any view Parameter interface { interface_type interface_ num | interface_name } [ to { interface_type interface_ num | interface_name } ]: Specifies ports. You can specify multiple sequential ports with the to parameter, instead of specifying only one port. interface_name: Specifies port name, in the format of interface_name = interface_type interface_num. interface_type: Specifies port type and interface_num port number. For more information, see the parameter item for the interface command.