3Com 5500G-EI Command Reference Guide - Page 392
stop-accounting-buffer, enable, Syntax, Parameter, Description, Example, timer
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 392 highlights
392 CHAPTER 11: USING AAA AND RADIUS COMMANDS stop-accounting-buffer Syntax enable stop-accounting-buffer enable undo stop-accounting-buffer enable View RADIUS Scheme View Parameter None Description Use the stop-accounting-buffer enable command to configure to save the stopping accounting requests without response in the Switch buffer. Use the undo stop-accounting-buffer enable command to cancel the function of saving the stopping accounting requests without response in the Switch buffer. By default, enable to save the stopping accounting requests in the buffer. Because the stopping accounting request concerns the account balance and will affect the amount of charge, which is very important for both the user and ISP, NAS shall make its best effort to send the message to the RADIUS accounting server. Accordingly, if the message from the Switch to the RADIUS accounting server has not been responded to, the Switch shall save it in the local buffer and retransmit it until the server responds or discard the messages after transmitting for a specified number of times. Related commands: reset stop-accounting-buffer, radius scheme, display stop-accounting-buffer. Example To indicate that, for the server "3Com" in the RADIUS scheme, the Switch will save the stopping accounting request packets in the buffer, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]radius scheme 3Com [SW5500-radius-3Com]stop-accounting-buffer enable timer Syntax timer seconds undo timer View RADIUS Scheme View Parameter seconds: RADIUS server response timeout timer, ranging from 1 to 10 and measured in seconds. By default, the value is 3.