3Com 5500G-EI Command Reference Guide - Page 132

132 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS Parameters ip_address1, ip_address2 Enter destination IP address, in dotted decimal format. ip_address1 and ip_address2 jointly define the address range. The FIB entries in this address range will be displayed. mask1, mask2, mask-length1, mask-length2 Enter the IP address mask, in dotted decimal format, or an integer in the range of 0 to 32 to represent the mask length. longer All FIB entries matching a specific destination IP address (range) . Description Use the display fib ip_address command to view the FIB entries matching the destination IP address (range). Each line outputs a FIB entry and the display contents for each entry include destination address/mask length, next hop, current flag, timestamp and outbound interface. Example To display the FIB entries whose destination addresses match 169.253.0.0 in natural mask range, enter the following: display fib 169.253.0.0 Route Entry Count: 1 Destination/Mask Nexthop Flag TimeStamp 169.0.0.0/16 2.1.1.1 U t[0] Interface Vlan-interface1 To display the FIB entries whose destination addresses are in the range of 169.254.0.0/16 to 169.254.0.6/16, enter the following: display fib 169.254.0.0 255.255.0.0 169.254.0.6 255.255.0.0 Route Entry Count: 1 Destination/Mask Nexthop Flag TimeStamp Interface 169.254.0.1/16 2.1.1.1 U t[0] Vlan-interface1 display fib acl Syntax display fib acl number View Any view Parameter number Enter the ACL in number form, in the range 2000 to 2999 Description Use the display fib acl command to view the FIB entries matching a specific ACL. Example To display the FIB entries matching ACL 2000, enter the following: display fib acl 2000 Route entry matched by access-list 2000: Summary counts: 1