3Com 5500G-EI Command Reference Guide - Page 274
Description, Example, pim neighbor-policy, Syntax, Parameter
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
274 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS Description Use the pim neighbor-limit command to limit the PIM neighbors on an interface. No neighbor can be added when the limit is reached. Use the undo pim neighbor-limit command to restore the default setting. By default, the PIM neighbors on the interface are limited to 128. If the existing PIM neighbors exceed the configured value during configuration, they will not be deleted. Example Limit the PIM neighbors on the Vlan-interface10 to 50. system-view System View: return to User View with Ctrl+Z [SW5500]multicast routing-enable [SW5500]interface Vlan-interface-10 [SW5500-Vlan-interface10]pim neighbor-limit 50 pim neighbor-policy Syntax pim neighbor-policy acl-number undo pim neighbor-policy View VLAN Interface View Parameter acl-number: Basic ACL number, in the range of 1to 99. Description Use the pim neighbor-policy command to filter the PIM neighbors on the current interface. Use the undo pim neighbor-policy command to remove the filter. Only the routers that match the filtering rule in the ACL can serve as a PIM neighbor of the current interface. The new configuration overwrites the old one if you run the command for a second time. Example Configure that 10.10.1.2 can serve as a PIM neighbor of the Vlan-interface10, but not 10.10.1.1. system-view System View: return to User View with Ctrl+Z [SW5500]multicast routing-enable [SW5500]interface Vlan-interface-10 [SW5500-Vlan-interface10]pim neighbor-policy 2000 [SW5500-Vlan-interface10]quit [SW5500]acl number 2000