3Com 5500G-EI Command Reference Guide - Page 59
Example, loopback-detection, enable, Syntax, Parameter, Description, interval-time
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Ethernet Port Configuration Commands 59 Example Enable port loopback detection control. system-view System View: return to User View with Ctrl+Z. [SW5500]interface Gigabitethernet 1/0/1 [SW5500-GigabitEthernet1/0/1]loopback-detection control enable loopback-detection Syntax enable loopback-detection enable undo loopback-detection enable View Ethernet Port View Parameter None Description Use the loopback-detection enable command to enable port loopback detection. If there is a loopback port found, the switch will put it under control. Use the undo loopback-detection enable command to disable port loopback detection. Loopback detection of a specified port only functions after port loopback detection is enabled in the System or Ethernet port view. By default, port loopback detection is disabled. Related commands: display loopback-detection Example To enable port loopback detection, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]loopback-detection enable loopback-detection Syntax interval-time loopback-detection interval-time time undo loopback-detection interval-time View System View Parameter time: Specifies the interval of monitoring external loopback conditions of the port. It ranges from 5 to 300, measured in seconds.