3Com 5500G-EI Command Reference Guide - Page 454
Parameter, Description, Example, count, Syntax, destination ip, HWPing Test Group View
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 454 highlights
454 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS View System View Parameter administrator-name: Specify the name of the administrator creating an HWPing test group. operation-tag: Test operation tag. Description Use the hwping command to create an HWPing test group. Executing this command allows the systemto access the HWPing test group view. Example Create an HWPing test group, where the administrator name is 'administrator' and the test operation tag is 'icmp'. [SW5500]hwping administrator icmp count Syntax count times undo count View HWPing Test Group View Parameter times: Number of test packets to be transmitted, in the range 1 to 15. Defaults to 1. Description Use the count command to configure the number of packets to be sent for each test. Use the undo count command to restore the deault. A test timer will start when the system send the first test packet. In the event that the times argument is set greater than one, the system continues to send the second one upon receipt of the reply of the first one. If receiving no reply upon expiry of the timer, the system sends the second and all the remaining packets likewise. Example Send ten packets for each test. [SW5500-administrator-icmp]count 10 destination ip Syntax destination-ip ip-address undo destination-ip