3Com 5500G-EI Command Reference Guide - Page 196
display ospf peer, Syntax, Parameter, Description, Example, Table 33
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
196 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS Table 33 Output Description of the display ospf nexthop Command Field Address Type Refcount Intf Addr Intf Name Description Address of the next hop Type of the next hop Reference count of the next hop, that is, number of routes using the next hop IP address of the interface to the next hop The interface to the next hop display ospf peer Syntax display ospf [ process-id ] peer [ brief ] View All Views Parameter process-id Enter the process ID of OSPF, ranging from 1 to 65535. The command is applied to all current OSPF processes if you do not specify a process ID. Description Use the display ospf peer command to view detailed OSPF peer information. Use the display ospf peer brief command to view brief information of every peer in the OSPF Autonomous System, in particular the peer number of all states in every area. Example To view the information on an SPF peer, enter the following: display ospf peer OSPF Process 1 with Router ID 1.1.1.1 The information displays in the following format: Neighbors Area 0.0.0.0 interface 10.153.17.88(Vlan interface1)'s neighbor(s) RouterID: 2.2.2.2 Address: 10.153.17.89 State: Full Mode: Nbr is Master Priority: 1 DR: 10.153.17.89 BDR: 10.153.17.88 Dead times expires in 31s Neighbor has been up for 01:14:14 Table 34 Output Description of the display ospf peer Command Field RouterID Address State Description Router ID of neighbor router Address of the interface, through which neighbor router communicates with the router State of adjacency relation