3Com 5500G-EI Command Reference Guide - Page 171
Parameter, Description, Example, rip metricin, Syntax
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
RIP Configuration Commands 171 Parameter None Description Use the rip input command to allow an interface to receive RIP packets. By default, all interfaces except loopback interfaces are able to receive RIP packets. Use the undo rip input command to block an interface from receiving RIP packets. This command is used in conjunction with two other two commands: rip output and rip work. The rip input and rip output commands control, respectively, the receipt and the transmission of RIP packets on an interface. The rip work command allows both receipt and tranmission of RIP packets. Related commands: rip output, rip work. Example To set the interface Vlan-interface 1 not to receive RIP packets, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]interface Vlan-interface 1 [SW5500-Vlan-interface1]undo rip input rip metricin Syntax rip metricin value undo rip metricin View Interface View Parameter value Enter an additional route metric to be added when receiving a packet, ranging from 0 to 16. By default, the value is 0. Description Use the rip metricin command to configure an additional route metric to be added to the route when an interface receives RIP packets. Use the undo rip metricin command to restore the default value of this additional route metric. Related command: rip metricout. Example To set the additional route metric to 2 when the interface Vlan-interface 1 receives RIP packets, enter the following: system-view System View: return to User View with Ctrl+Z.