3Com 5500G-EI Command Reference Guide - Page 321
Spanning Tree Protocol RSTP., port. If no port is specified
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 321 highlights
RSTP Configuration Commands 325 Parameter interface interface_list: Specifies the Ethernet port list, including multiple Ethernet ports. Expressed as interface _list = { { interface_type interface_num | interface_name } [ to { interface_type interface_num | interface_name } ] }&. For details about interface_type, interface_num and interface_name, refer to the port command in this manual. &: Indicates the preceding parameter can be input up to 10 times. Description Use the reset stp command to reset the statistics information about Rapid Spanning Tree Protocol (RSTP). This command can be used to clear the statistics information about a specified port. If no port is specified, the statistics information of all the ports of the device will be cleared. Related command: display stp. Example To clear the statistics information about GigabitEthernet1/0/1 through GigabitEthernet1/0/3, enter the following: reset stp interface GigabitEthernet1/0/1 to GigabitEthernet1/0/3 stp Syntax stp { enable | disable } undo stp View Ethernet Port View Parameter enable: Enables RSTP on a device or a port. disable: Disables RSTP on a device or a port. Description Use the stp enable command to enable RSTP on a device or port. Use the stp disable command to disable RSTP on a device or port. Use the undo stp command to disable RSTP on a device. By default, RSTP is enabled on the Switch and all ports. If the parameters of RSTP have not been set for the device or the ports before RSTP is enabled on the device, they will take the default values. Before or after RSTP is enabled, you can use the configuration command to set RSTP parameters