3Com 5500G-EI Command Reference Guide - Page 147
display ip routing-table, Syntax, Parameters, Description, Example
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Routing Table Display Commands 147 3.3.3.0/24 3.3.3.1/32 4.4.4.0/24 4.4.4.1/32 127.0.0.0/8 127.0.0.1/32 DIRECT 0 0 DIRECT 0 0 DIRECT 0 0 DIRECT 0 0 DIRECT 0 0 DIRECT 0 0 3.3.3.1 127.0.0.1 4.4.4.1 127.0.0.1 127.0.0.1 127.0.0.1 Vlan-interface3 InLoopBack0 Vlan-interface4 InLoopBack0 InLoopBack0 InLoopBack0 Table 17 Output Description of the display ip routing-table Command Field Destination/Mask Protocol Pre Cost Interface Description Destination address/Mask length Routing protocol Routing preference Cost Output interface, through which the data packet destined for the destination network is sent display ip routing-table Syntax acl display ip routing-table acl acl_number [ verbose ] View All views. Parameters acl_number Enter the number of the IP ACL, in the range 2000 to 2999. verbose Enter to display verbose information about both the active and inactive routes that passed filtering rules. If you do not enter this parameter, the command only displays a summary of the active routes that passed filtering rules. Description Use the display ip routing-table acl command to view the route filtered through the specified ACL. This command is used to display the routes that passed the filtering rules in the specified ACL. The command only displays routes that passed basic ACL filtering rules. Example To display a summary of the active routes filtered through basic ACL 2000, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]acl number 2000 [SW5500-acl-basic-2000]rule permit source 10.1.1.1 0.0.0.255 [SW5500-acl-basic-2000]rule deny source any [SW5500-acl-basic-2000]display ip routing-table acl 2000 The information displays in the following format: