3Com 5500G-EI Command Reference Guide - Page 127
display isolate port, Syntax, Parameter, Description, Example, port isolate
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Access Management Configuration Commands 127 Table 11 Output Description of the display am Command Field Status IP Pools Description AM state on the port: enabled or disabled IP pools. NULL represents no configuration. Each IP address section is represented in X.X.X.X (number), of these, "X.X.X.X" represents the first address, and "number" represents that "number" consecutive IP addresses from the beginning of this address are within the IP pools display isolate port Syntax display isolate port View Any view Parameter none Description Use the display isolate port command to view port isolation information. Example To display port isolation information, enter the following: display isolate port UNIT 1: Ethernet1/0/1 port isolate Syntax port isolate undo port isolate View Ethernet Port View Parameter None Description Use the port isolate command to add a port to an isolation group using the following commands, and achieves port-to-port isolation between this port and other ports of this group, that is, Layer 2 forwarding between the isolated ports is not available. Use the undo port isolate command to remove a port from an isolation group. By default, a port is not in an isolation group, namely Layer 2 forwarding is achievable between this port and other ports.