Home » 3Com Manuals » Hubs & Switches » 3Com 5500G-EI » Manual Viewer

3Com 5500G-EI Command Reference Guide - Page 438

Parameter, Description, Example, display fan, Syntax, display memory

UPC - 662705493534

Add to My Manuals
Save this manual to your list of manuals

Page 438 highlights

438 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS Parameter unit unit-id: Specify the Unit ID of the switch. Description Use the display device command to display the module type and working status information of a card, including physical card number, physical daughter card number, number of ports, hardware version number, FPGA version number, version number of BOOTROM software, application version number, address learning mode, interface card type and interface card type description, etc. Example Show device information. display device display fan Syntax display fan [ unit unit-id ] View All views Parameter unit unit-id: Specify the Unit ID of the switch Description Use the display fan command to display the working state of the built-in fans. Example Display the working state of the fans. display fan Unit 1 Fan 1 State: Normal Fan 2 State: Normal The above information indicates that the fan works normally. display memory Syntax display memory [ unit unit-id ] View All views Parameter unit unit-id: Specify the Unit ID of the switch Description Use the display memory command to display the current system memory status.

Section	Page
About This Guide	19
Using System Access Commands	23
Using Port Commands	47
Using VLAN Commands	79
Using Power over Ethernet (PoE) Commands	91
Using Network Protocol Commands	101
Using Routing Protocol Commands	143
Using Multicast Protocol Commands	235
Using QoS/ACL Commands	281
Using RSTP Commands	317
Using Fabric Commands	337
Using AAA and RADIUS Commands	341
Using System Management Commands	397