3Com 5500G-EI Command Reference Guide - Page 442

442 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS Two formats can be used to set the waiting delay of timing reboot switch, namely the format of "hour: minute" and the format of "absolute minutes". But the total minutes should be no more than 30×24×60 minutes, or 30 days. After this command is configured, the system will prompt you to input confirmation information. Only after the "Y" or the "y" is entered can the configuration be valid. If there is related configuration before, it will be covered directly. After the schedule reboot at command is configured, and the system time is adjusted by the clock command, the original schedule reboot at parameter will become invalid. For the related command, see reboot, schedule reboot at, undo schedule reboot, display schedule reboot Example Configure the switch to be restarted after 88 minutes (the current time is 21:32). schedule reboot delay 88 Reboot scheduled for 23:00:00 UTC 2002/11/1 (in 1 hours and 28 minutes) Proceed with reboot? [Y/N]:y Basic System Configuration and Management Commands This section describes the basic system configuration and system management commands available on your Switch 5500G-EI. clock datetime Syntax clock datetime time date View User view Parameters time : enter the current time in HH:MM:SS format . HH can be in the range 0 to 23. MM and SS can be in the range 0 to 59. date : enter the current year in MM/DD/YYYY or YYYY/MM/DD format . YYYY can be in the range 2000 to 2099. MM can be in the range 1 to 12. DD can be in the range 1 to 31. Description Use the clock datetime command to set the current system time and date. The default is 23:55:52, 2000/4/1. Related command: display clock Example To set the system time and date to 09:30:00, 2004/1/1, enter the following: